1. Hold the RFID Equipment Card in front of the RFID reader.
Users are always logged on with access level 2.
8 8 p s i 0 8 : 1 5 A M 1 7 6 ° F
Header
Log-in successful
Menu
Button to change password
Prompt, whether the password is to be changed
------------------------------
Name: E00019895
Level: 2
2. Press the «Right» key within five seconds.
The new
Password
is displayed.
8 8 p s i 0 8 : 1 5 A M 1 7 6 ° F
Header
Password changed
Menu
------------------------------
Please take note of your new
password:
xFNDQRCnDn
New password
3. Note the new password.
4. Store the password at a suitable location, if it should become necessary to manually log-on
without RFID Equipment Card.
5. Press «Enter».
The setting is applied.
8.2.6 Manual user log-in
In the event that your RFID Equipment Card is damaged or lost, you can manually log on to
SIGMA CONTROL 2.
Precondition The user name (see chapter 8.2.3) and password (see chapter 8.2.5) are known.
The operating mode is displayed.
1. Open the 7
User
menu.
2. Use «Up» or «Down» to select the
Name
line.
3. Press «Enter».
The setting mode is active.
A column with alphanumeric characters is displayed.
The selected character flashes.
8 Initial Start-up
8.2 Setting the controller
No.: 9_9450 13 USE
User Manual Controller
SIGMA CONTROL 2 SCREW FLUID ≥5.1.2
59
To Next Page
Loading...
Need help?
General