KAESER SIGMA CONTROL 2 - Set display formats

➤ Carry out settings as required:
■ 8.2.1: Selecting menu options (introduction)
■ 8.2.2: Setting the language
■ 8.2.3: Noting the user name
■ 8.2.4: User log-in with RFID Equipment Card
■ 8.2.5: Generating a password
■ 8.2.6: Manual user log-in
■ 8.2.7: Create the master RFID Equipment Card
■ 8.2.8: Checking/Setting time and date
■ 8.2.9: Setting the time zone (daylight saving time/winter time)
■ 8.2.10: Set display formats (date, time, units of pressure and temperature)
■ 8.2.11: Setting the display illumination
■ 8.2.12: Setting the contrast and the brightness
■ 8.2.13: Activating the remote control
■ 8.2.14: IP configuration
■ 8.2.15: Setting the e-mail function
■ 8.2.16: Setting the time server
■ 8.3.6: Creating a user account
8.2.1 Selecting menu options
All menu options can be selected with the «Down», «Up» and «Enter» keys.
Example: Open the < Configuration – General > menu.
1. Switch on the machine and wait for SIGMA CONTROL 2 to start.
The operating mode is displayed.
8 8 p s i 0 8 : 1 5 A M 1 7 6 ° F
Header
------------------------------
Load
Current operating mode
------------------------------
Key – on ¦ pA – on
Operating parameters
------------------------------
Run 2500h Load 2490h
Operating parameters
Maintenance in 500h
Maintenance indicator
8 Initial Start-up
8.2 Setting the controller
54
User Manual Controller
SIGMA CONTROL 2 SCREW FLUID ≥5.1.2 No.: 9_9450 13 USE