KAESER SIGMA CONTROL 2 User Manual

Secure storage of RFID Equipment Cards
2 RFID Equipment Cards are supplied with each machine.
They are stored in a plastic sleeve.
The plastic sleeve is attached to the rear of the controller inside the control cabinet.
In the event that both RFID Equipment Cards are lost, you can only register a new RFID Equip‐
ment Card by entering a user name and password. Should the user name and password also be
lost, a new RFID Equipment Card may be registered via an KAESER service partner. There will be
a charge for this service.
5.5 KAESER CONNECT
Using an Internet-capable device with web browser, you can access a visualization of the control‐
ler. This enables, for example, the operating and energy efficiency of your machine to be checked
remotely. To do so, you must generate a one-time password (see Chapter 8.2.5). KAESER
CONNECT does not require additional software for this purpose. The display language for
KAESER CONNECT can be set independently of the language used in the SIGMA CONTROL 2.
Fig. 10 KAESER CONNECT for SIGMA CONTROL 2
KAESER CONNECT functions:
Operating element Meaning
read => write Switches from read-only to write mode
To create users and acknowledge messages
write => read Switch from write to read-only mode
Logout Log the user out
Contact/Service Display contact information for an authorized KAESER service representative
12)
not on AIRTOWER
5 Design and Function
5.5 KAESER CONNECT
26
User Manual Controller
SIGMA CONTROL 2 SCREW FLUID ≥5.1.2 No.: 9_9450 13 USE

KAESER SIGMA CONTROL 2 Specifications

General

Controller Type	Microprocessor-based
Model	SIGMA CONTROL 2
Manufacturer	KAESER
Input Voltage	24 V DC
Protection Class	IP54
Communication Protocols	Modbus, Profibus
Data Logging	Comprehensive data logging
Remote Monitoring	Yes
Communication Interface	Ethernet