KAESER SIGMA CONTROL 2 User Manual

4. Press the «Enter» key.
Setting mode is active.
5. Press the «Right» key repeatedly until the check box Reset: is indicated.
6. Press the «Enter» key.
Setting mode is active.
The check box Reset: will flash.
7. Press the «Up» key.
The check box is activated.
8 8 p s i 0 8 : 1 5 A M 1 7 6 ° F
Header
4 Maintenance
▶1 External counter
·········
Oil filter
4000h¦ 4000h Reset: ☒
Active line with activated check box
·········
Oil separator
8. Press the «Enter» key.
The display stops flashing and the maintenance counter Oil change is reset.
The check box Reset: is deactivated again.
8 8 p s i 0 8 : 1 5 A M 1 7 6 ° F
Header
4 Maintenance
▶1 External counter
·········
Oil filter
4000h¦ 0h Reset: ☐
Active line, the maintenance counter has been re‐
set, the Reset check box has been deactivated
·········
Oil separator
9. Press the «Escape» key repeatedly to return to the main menu.
9.12 External maintenance counter
Up to three external maintenance counters can be configured for system-specific monitoring. The
text displayed for the maintenance counter and the deadline for the maintenance interval can be
set individually.
Set text for a maintenance counter
Precondition Password access level 2 is activated
The operation display is shown
1. Open the 4 Maintenance menu.
9 Operation
9.12 External maintenance counter
No.: 9_9450 13 USE
User Manual Controller
SIGMA CONTROL 2 SCREW FLUID ≥5.1.2
187

KAESER SIGMA CONTROL 2 Specifications

General

Controller Type	Microprocessor-based
Model	SIGMA CONTROL 2
Manufacturer	KAESER
Input Voltage	24 V DC
Protection Class	IP54
Communication Protocols	Modbus, Profibus
Data Logging	Comprehensive data logging
Remote Monitoring	Yes
Communication Interface	Ethernet