KAESER SIGMA CONTROL 2 User Manual

Depending on the selected language, the system automatically sets the units and the time
and date formats. You can manually change these settings (see chapter 8.2.10).
Precondition The operating mode is displayed.
1. Press «Enter».
The Main menu is displayed.
8 8 p s i 0 8 : 1 5 A M 1 7 6 ° F
Header
Main menu
----------------English US----------------
Current language
▶1 Status
Active line
▶2 Performance data
Sub-menu
▶3 Operating data
Sub-menu
▶4 Maintenance
Sub-menu
▶5 Configuration
Sub-menu
2. Press «Up» key.
The currently set language is displayed.
8 8 p s i 0 8 : 1 5 A M 1 7 6 ° F
Header
Main menu
----------------English US----------------
Active line with current set language
▶1 Status
Sub-menu
▶2 Performance data
Sub-menu
▶3 Operating data
Sub-menu
▶4 Maintenance
Sub-menu
▶5 Configuration
Sub-menu
3. Press «Enter».
The currently set language flashes.
4. Use «Up» or «Down» to select the desired language.
5. Press «Enter».
Result The user interface is displayed in the set language.
8.2.3 Noting the user name
The number of your RFID Equipment Card is identical with the user name displayed on
SIGMA CONTROL 2 after you have successfully logged on using your RFID Equip‐
ment Card.
8 Initial Start-up
8.2 Setting the controller
56
User Manual Controller
SIGMA CONTROL 2 SCREW FLUID ≥5.1.2 No.: 9_9450 13 USE

KAESER SIGMA CONTROL 2 Specifications

General

Controller Type	Microprocessor-based
Model	SIGMA CONTROL 2
Manufacturer	KAESER
Input Voltage	24 V DC
Protection Class	IP54
Communication Protocols	Modbus, Profibus
Data Logging	Comprehensive data logging
Remote Monitoring	Yes
Communication Interface	Ethernet