KAESER SIGMA CONTROL 2 User Manual

3. Press «Enter».
The check box Key remote will flash.
8 8 p s i 0 8 : 1 5 A M 1 7 6 ° F
Header
8 Communication
Menu
▶1 Ethernet/SIGMA NETWORK
▶2 Com-Module
Key remote : ☐
Active line with deactivated check box
4. Press «Up» key.
The check box Key remote is activated.
8 8 p s i 0 8 : 1 5 A M 1 7 6 ° F
Header
8 Communication
Menu
▶1 Ethernet/SIGMA NETWORK
▶2 Com-Module
Key remote : ☑
Active line with activated check box
5. Press «Enter».
The «Remote control» key is activated.
6. Press «Escape» repeatedly to leave this menu.
Proceed in the same manner to deactivate the «remote control» key.
7. Press «Remote control» key on the operating panel of SIGMA CONTROL 2.
Result SIGMA CONTROL 2 remote control is activated.
8.2.14 IP configuration
For the SIGMA CONTROL 2 to be connected to the network, you must set the IP configuration (for
KAESER CONNECT for example).
If you use SIGMA CONTROL 2 as the master control of two machines, you set other network
parameters in the IP configuration menu (see chapter 8.10.4).
The network parameters for the IP configuration must be specified manually. You cannot use
DHCP for an automatic IP configuration.
Precondition Password access level 2 is activated.
The network parameters are known. Request the required information from your IT department.
1. Connect SIGMA CONTROL 2 to the network using an Ethernet cable.
2. Select the 8.1.1 <Communication – Ethernet/SIGMA NETWORK – IP configuration> menu.
8 Initial Start-up
8.2 Setting the controller
68
User Manual Controller
SIGMA CONTROL 2 SCREW FLUID ≥5.1.2 No.: 9_9450 13 USE

KAESER SIGMA CONTROL 2 Specifications

General

Controller Type	Microprocessor-based
Model	SIGMA CONTROL 2
Manufacturer	KAESER
Input Voltage	24 V DC
Protection Class	IP54
Communication Protocols	Modbus, Profibus
Data Logging	Comprehensive data logging
Remote Monitoring	Yes
Communication Interface	Ethernet