KAESER SIGMA CONTROL 2 - Page 239

Message Meaning
0201 O
IOSlot2 Undervoltage error %d
Internal voltage monitoring reports low voltage fault IO‐
Slot2
0202 O
IOSlot3 Undervoltage error %d
Internal voltage monitoring reports low voltage fault IO‐
Slot3
0300 O
Cycle-exact data recording active
Service information
0301 O
SD card defective!
Service information
0500 O
Safety shutdown "IOMDiagnosis()"
Service information
0501 O
Safety shutdown "Safeguard()"
Service information
0550 O
ADT channel error "currleak"
detected
Short-term overload fault without shut-down occurred at
ADT.
0551 O
ADT channel error "channel open"
detected
Short-term overload fault without shut-down occurred at
ADT.
0850 O
IOSlot%d - bus error
Temporary IOM bus fault without shutdown has occurred
0867 O
AII%d.0%d - overload fault
Short-term overload fault without shut-down occurred at
All.
0873 O
AII%d.0%d - overload fault
Short-term overload fault without shut-down occurred at
All.
0879 O
AII%d.0%d - overload fault
Short-term overload fault without shut-down occurred at
All.
0885 O
AII%d.0%d - overload fault
Short-term overload fault without shut-down occurred at
All.
1000 O
2 RFID Equipment Cards
successfully registered
You successfully registered 2 RFID Equipment Cards at
the controller.
1018 O
IOSlot%d - bus error
Temporary IOM bus fault without shutdown has occurred
1035 O
AII%d.0%d - overload fault
Temporary overload fault without shutdown occurred at AII.
1041 O
AII%d.0%d - overload fault
Temporary overload fault without shutdown occurred at AII.
1047 O
AII%d.0%d - overload fault
Temporary overload fault without shutdown occurred at AII.
1053 O
AII%d.0%d - overload fault
Temporary overload fault without shutdown occurred at AII.
10 Fault Recognition and Rectification
10.4 Interpreting operating messages
No.: 9_9450 13 USE
User Manual Controller
SIGMA CONTROL 2 SCREW FLUID ≥5.1.2
229