KAESER SIGMA CONTROL 2 - Status menu

5.6.2.1 Status menu
Navigation Function / Submenu
1.1 Messages ■ Current messages
■ Message history
─ Compressor messages
─ Diagnostic messages
─ System messages
■ Address error
─
Incorrect parameterisation in
2)
Status report
current Alarms
current Warnings
1.2 Statistics Load (hours)
since/Reset:
Load (speed)
1) 4)
since/Reset:
Network actual pressure pNloc
Internal pressure
Motor starts total
since/Reset:
Motor starts per day
Motor starts per hour
Motor starts T↓
Last load run
Last idle run
12)
Last motor off
1.3 Current pressure control SIGMA CONTROL 2
Cut-out pressure
SP/SD
Network actual pressure
Frequency converter
1) 4)
Setpoint pressure
1) 4)
Actual pressure
1) 4)
Speed nominal value
1) 4)
Speed actual value
1) 4)
Speed limits
1) 4)
1)
Power switching with frequency converter
2)
Only visible in the event of a parameterization error
3)
SIGMA CONTROL 2 (Prepared for connection to control center)
4)
SIGMA CONTROL 2 FLUID
12)
Not for AIRTOWER
5 Design and Function
5.6 Menu overview
32
User Manual Controller
SIGMA CONTROL 2 SCREW FLUID ≥5.1.2 No.: 9_9450 13 USE