KAESER SIGMA CONTROL 2 - Page 81

6. Set the e-mail parameters as described above:
If SIGMA CONTROL 2 is connected via SIGMA NETWORK to SAM 4.0 and e-mails are to be
forwarded via SAM 4.0, then enter the IP address of interface X6 of SAM 4.0 in the SMTP
Server: field. 169.254.100.100 (see also chapter 8.10.2). Enter at port address of the SMTP
server: 25.
For SAM 4.0 the option Data Forwarding in the menu <Configuration - E-mail - Basic Set‐
tings> must be activated.
Parameter Setting
value
Meaning
Compressor
number:
This field displays the machine number that appears as the sender of
e-mails. The recipient is thus able to identify the different machines
sending mails.
Language: Use this field to define the language for the message texts. This setting
is independent from the language setting in SIGMA CONTROL 2 (see
chapter 8.2.2).
Repeat cut-off
time:
In this field, enter the time in minutes (repeat block time) that the sys‐
tem must wait in order not to send multiple recurring messages in short
time intervals.
Use SSL: E-mail sending is encrypted if the check box is marked.
Sender address: Enter the e-mail address of the sender in this field.
Sender name: Enter the name of the sender in this field.
Contact
telephone:
In this field, enter a telephone number under which the air station oper‐
ator can be reached. This telephone number is sent with each e-mail.
Receiver
address:
The e-mail address of the recipient.
SMTP Server: IP address of the SMTP server receiving and forwarding the e-mails.
User name: Log-in user name for logging on to the SMTP server.
Password Log-in password for logging on to the SMTP server.
Port Port address of the SMTP server.
Timeout In this field, enter the seconds for SIGMA CONTROL 2 to wait for a re‐
ply by the SMTP server before e-mail sending is cancelled.
Resend after: In this field, enter the time in seconds for the system to wait after a
failed e-mail sending operation before it again attempts to send the
mail.
Retry attempts: Setting option for the number of attempts to resend after failed e-mail
sending.
Tab. 51 E-mail parameters
7. Activating the e-mail function: Activate the active: check box as described above.
8. Press «Escape» repeatedly to leave this menu.
Result The e-mail parameters are set and the e-mail function is activated.
8 Initial Start-up
8.2 Setting the controller
No.: 9_9450 13 USE
User Manual Controller
SIGMA CONTROL 2 SCREW FLUID ≥5.1.2
71