Keysight E4980A - Turning On;Off the Beep Feature

Keysight E4980A/AL Precision LCR Meter 155
System Configurations
SYSTEM CONFIG Page
Turning On/Off the Beep Feature
Functional Description
The E4980A/AL has a beep feature that generates beeps when one or more of
the following conditions occur:
• An error message or warning message has appeared.
• The instrument has completed open/short correction.
• The instrument has completed open/short/load correction at user-specified
frequency points.
• The DUT has failed the limit test or has been sorted as OUT OF BIN/AUX
BIN by the comparator.
1
• The DUT has passed the limit test or has been sorted into one of bins 1
through 9 by the comparator.
1
• You have turned on/off the key lock.
Regardless of whether the beep feature is on or off, beeps are generated
whenever:
• E4980A/AL starts up.
• You change the beep tone through the front panel.
To set up the beep feature:
Step 1. Press [System].
Step 2. Press the SYSTEM CONFIG softkey.
Step 3. Use the cursor keys to select the BEEPER ENABLED field.
Step 4. Turn on or off the beep feature by pressing the appropriate softkey:
1. You can use the BEEP field on the LIST SWEEP SETUP page or the COMP:BEEP com-
mand to turn on/off the beep feature for the comparator.
The beep feature does not support volume control.
Softkey Description
ON Turns ON the beep feature.
OFF Turns OFF the beep feature.