Keysight E4980A - MEAS SETUP page

88 Keysight E4980A/AL Precision LCR Meter
Configuring Measurement Conditions (Display and Function Related Settings)
MEAS SETUP page
4-
MEAS SETUP page
You can press the [Meas Setup] key to open the MEAS SETUP page. In the
MEAS SETUP page, you can configure each of the following measurement
controls with the cursor placed in the corresponding field (denoted in
parentheses).
• Comment line (USER COMMENT field)
•Measurement function (FUNC field)
• Measurement range (RANGE field)
• Measurement frequency (FREQ field)
• DC bias (BIAS field)
• Measurement signal level (LEVEL field)
• Measurement time mode (MEAS TIME field)
• Trigger mode (TRIG field)
• averaging factor (AVG field)
• Automatic level control (ALC field)
• Signal voltage level monitor ON/OFF (VDC MON field)
• DC resistance range (DCR RNG field)
• Signal current level monitor ON/OFF (IDC MON field)
• Bias current isolation (DCI ISO field)
• Trigger delay time (TRIG DLY field)
• DC current (DCI) range (DCI RNG field)
• Step delay time (STEP DLY field)
• DC source (DC SRC field)
• Automatic bias polarity control (BIAS POL)
• Deviation measurement mode A (DEV A field)
• Reference value for deviation measurement mode A (REF A field)
• Deviation measurement mode B (DEV B field)
• Reference value for deviation measurement mode B (REF B field)
The following fields are accessible through both the MEAS SETUP and MEAS
DISPLAY pages:
•Measurement function (FUNC field)
• Measurement range (RANGE field)
• Measurement frequency (FREQ field)