Keysight E4980A - Initiate:continuous; Initiate[:Immediate]; List:band[1-201]

352 Keysight E4980A/AL Precision LCR Meter
SCPI Command Reference
E4980A/AL commands
10-
Open "C:\TEST.gif" For Binary As #1
For i = 0 To Nop - 1
Put #1, , GifData(i)
Next i
Close
Equivalent key No equivalent key is available on the front panel.
:INITiate:CONTinuous
Syntax :INITiate:CONTinuous {ON|OFF|1|0}
:INITiate:CONTinuous?
Description Enables the automatic trigger to change state from the “Idle” state to the “Wait
for Trigger” state. Refer to the chapter on Remote Control.
Parameter
Equivalent key No equivalent key is available on the front panel.
:INITiate[:IMMediate]
Syntax :INITiate[:IMMediate]
Description Initiates the trigger to change from the Idle” state to the “Wait for Trigger”
state one time. Refer to the chapter on Remote Control. (No Query)
Equivalent key No equivalent key is available on the front panel.
:LIST:BAND[1-201]
Syntax :LIST:BAND[1-201] {A|B|OFF},<low>,<high>
:LIST:BAND[1-201]?
Pressing [Save/Recall] - SAVE DISPLAY key saves the current screen
image into the USB memory.
Description
ON or 1 Enables automatic trigger state change
OFF or 0 (Preset value) Disables automatic trigger state change