Keysight E4980A - Source:dcsource:state; Source:dcsource:voltage[:Level]

Keysight E4980A/AL Precision LCR Meter 363
SCPI Command Reference
E4980A/AL commands
Parameter
Equivalent key No equivalent key is available on the front panel.
:SOURce:DCSource:STATe
Syntax :SOURce:DCSource:STATe {ON|OFF|1|0}
:SOURce:DCSource:STATe?
Description Enables the DC Source. The DC source is automatically turned OFF after
recalling the state from memory. When DC Source is set to ON, DC Source
voltage that has been set with :SOURce:DCSource:VOLTage[:LEVel] is output.
Parameter
Equivalent key [DC Source]
:SOURce:DCSource:VOLTage[:LEVel]
Syntax :SOURce:DCSource:VOLTage[:LEVel] <numeric>
:SOURce:DCSource:VOLTage[:LEVel]?
Description Sets the DC source’s voltage level
Description
ON or 1 Does nothing
OFF or 0 (Preset value) Does nothing
This is available when option 001 is installed.
Description
ON or 1 Enables the DC Source
OFF or 0 (Preset value) Disables the DC Source
This is available when option 001 is installed.