254 Keysight E4980A/AL Precision LCR Meter
Overview of Remote Control
Data Buffer Memory
8-
Output Format of Data Buffer Memory
There are two formats returned by the :MEM:READ? DBUF command: ASCII
and BINARY. Each format is described below. For sample programs using the
data buffer memory (output format: ASCII and BINARY), refer to the chapter on
sample programs.
o ASCII Format
Figure 8-18 below shows the output format when the ASCII format is
selected as the data format. The data format and meaning of <DATA A>,
<DATA B>, <STATUS>, <BIN No.>, or <IN/OUT> are the same as those of the
ASCII data format described in Data Format of “Data Transfer” on page 260
Figure 8-17 ASCII format (Buffer memory)
o BINARY Format
Figure 8-19 shows the output format when the BINARY format is selected
as the data format. The data format and meaning of <DATA A>, <DATA B>,
<STATUS>, <BIN No.>, or <IN/OUT> are the same as those of the BINARY
data format described in Data Format of “Data Transfer” on page 260
㪼㪋㪐㪏㪇㪸㫌㪼㪈㪇㪉㪇
㪪㪥㪅㪥㪥㪥㪥㪥㪥㪥㪥㪥㪜㪪㪥㪥 㪪㪥㪅㪥㪥㪥㪥㪥㪥㪥㪥㪥㪜㪪㪥㪥
㪥㪣㪵㪜㪥㪛
㪪㪥 㪪㪥
㪪㪥㪅㪥㪥㪥㪥㪥㪜㪪㪥㪥 㪪㪥㪅㪥㪥㪥㪥㪥㪜㪪㪥㪥
㪥㪣㪵㪜㪥㪛
㪪㪥 㪪㪥
(14/#5%.10)1((
(14/#5%.10)10
## #$ 56#675 $+00Q
+0176
QT
## #$ 56#675 $+00Q
+0176
QT
To Next Page
Loading...
