Keysight E4980A - Function:smonitor:iac[:State]

Keysight E4980A/AL Precision LCR Meter 349
SCPI Command Reference
E4980A/AL commands
Equivalent key The softkeys of [Display Format] - MEAS DISPLAY - FUNC field
The softkeys of [Meas Setup] - MEAS SETUP - FUNC field
:FUNCtion:SMONitor:IAC[:STATe]
Syntax :FUNCtion:SMONitor:IAC[:STATe] {ON|OFF|1|0}
:FUNCtion:SMONitor:IAC[:STATe]?
Description Does nothing. The E4980A/AL always has the AC current-level monitor turned
ON. This function is provided because of its command compatibility with
4284A.
CSD Sets the Impedance Parameter Type to “Cs-D”
CSQ Sets the Impedance Parameter Type to “Cs-Q”
CSRS Sets the Impedance Parameter Type to “Cs-Rs”
LPD Sets the Impedance Parameter Type to “Lp-D”
LPQ Sets the Impedance Parameter Type to “Lp-Q”
LPG Sets the Impedance Parameter Type to “Lp-G”
LPRP Sets the Impedance Parameter Type to “Lp-Rp”
LPRD
1
Sets the Impedance Parameter Type to “Lp-Rdc”
LSD Sets the Impedance Parameter Type to “Ls-D
LSQ Sets the Impedance Parameter Type to 'Ls-Q'
LSRS Sets the Impedance Parameter Type to “Ls-Rs”
LSRD
1
Sets the Impedance Parameter Type to “Ls-Rdc”
RX Sets the Impedance Parameter Type to “R-X”
ZTD Sets the Impedance Parameter Type to “Z-thd”
ZTR Sets the Impedance Parameter Type to “Z-thr”
GB Sets the Impedance Parameter Type to “G-B”
YTD Sets the Impedance Parameter Type to “Y-thd”
YTR Sets the Impedance Parameter Type to “Y-thr”
VDID Sets the Impedance Parameter Type to “Vdc-Idc”
1. This can be set only when option 001, 030, 050, 100 or 200 is installed.
Description