Keysight E4980A - Step Delay Time

Keysight E4980A/AL Precision LCR Meter 101
Configuring Measurement Conditions (Display and Function Related Settings)
MEAS SETUP page
Step Delay Time
Functional Description
The step delay time feature of the E4980A/AL allows you to the delay the start
of measurement at each step and before starting measurement by the
automatic bias polarity control feature.
You can set the step delay time within the range of 0 through 999 s (seconds)
in minimum units of 100 s.
To set the step delay time:
Step 1. Press [Meas Setup].
Step 2. Using the cursor keys, select the STEP DLY field.
Step 3. Enter the step delay time using the softkeys or entry keys. If you use the entry
keys to enter the value, the softkey labels change to unit labels (ms, s).
Softkey Description
INCR ++ Increments step delay time in resolution steps shown in Table 4-4.
INCR + Increments step delay time in resolution steps shown in Table 4-5.
DECR - Decrements step delay time in resolution steps shown in Table 4-5.
DECR -- Decrements step delay time in resolution steps shown in Table 4-4.
Table 4-4 Resolution steps when setting the step delay time with INCR ++ / DECR --
INCR ++ / DECR -- (s)
0
1 m, 2 m, 3 m, •••, 9 m
10 m, 20 m, 30 m, •••, 90 m
100 m, 200 m, 300 m, •••, 900 m
1, 2, 3, •••, 9
10, 20, 30, •••, 90
100, 200, 300, •••, 900, 999