Keysight E4980A - Detecting End of Measurement

282 Keysight E4980A/AL Precision LCR Meter
Sample Program
Detecting End of Measurement
9-
Detecting End of Measurement
This application program detects the end of measurement with the status byte
after the E4980A/AL is triggered.
The program of Example 9-2 is described in detail below.
Configuration Assigns variables and enables error handling by the
subroutine named ErrorHandler.
Open Instrument Assigns a USB address or GPIB address to the I/O bus. Also
sets the attribute for timeout processing.
Setup Start Sets the trigger and status byte.
STB Check Waits until the status byte becomes 192. Displays the status
byte while waiting and again after processing.
Setup End Closes the I/O bus.
ErrorProc Displays an error number when an error occurs.