Keysight E4980A - Preparations before Use

Keysight E4980A/AL Precision LCR Meter 21
Unpacking and Preparation
Preparations before Use
Preparations before Use
Verifying the Power Supply
Confirm that the power supplied to the E4980A/AL meets the following
requirements:
Setting up the Fuse
Please use the following fuse type.
UL/CSA type, Slo-Blo, 520-mm miniature fuse, 3 A, 250 V (Keysight part
number 2110-1017)
When you need a fuse, contact your nearest Keysight Technologies sales and
service office. To verify and replace the fuse, remove the power cable and pull
out the fuse holder.
Figure 1-2 Fuse Holder and Power Cable Receptacle
Table 1-2 Power Supply Requirements
Requirements
Voltage
90 to 132 Vac or 198 to 264 Vac
1
Frequency 47 to 63 Hz
Maximum power
consumption
150 VA
1. Switched automatically by the E4980A/AL in conformity with the voltage used.
㪼㪋㪐㪏㪇㪸㫌㪼㪈㪇㪇㪏
㪝㫌㫊㪼㩷㪿㫆㫃㪻㪼㫉
㪧㫆㫎㪼㫉㩷㪚㪸㪹㫃㪼㩷㪠㫅㫃㪼㫋