Keysight E4980A - Trigger:source; Trigger:tdel

374 Keysight E4980A/AL Precision LCR Meter
SCPI Command Reference
E4980A/AL commands
10-
:TRIGger:SOURce
Syntax :TRIGger:SOURce {INTernal|HOLD|EXTernal|BUS}
:TRIGger:SOURce?
Description Selects the trigger mode.
Parameter
Equivalent key [Meas Setup] - MEAS SETUP - TRIG - INT
[Meas Setup] - MEAS SETUP - TRIG - MAN
[Meas Setup] - MEAS SETUP - TRIG - EXT
[Meas Setup] - MEAS SETUP - TRIG - BUS
:TRIGger:TDEL
Syntax :TRIGger:TDEL <numeric>
:TRIGger:TDEL?
Description Sets the trigger delay time.
Parameter
Equivalent key [Meas Setup] - TRIG SETUP - TRIG DLY
Description
INTernal (Preset value) Sets trigger source to “internal”
HOLD Sets trigger source to “manual”
EXTernal Sets trigger source to “external connector on the rear
panel”
BUS Sets trigger source to “GPIB/LAN/USB”
<Numeric>
Range 0 to 999
Preset value 0
Unit s
Resolution 100 