Keysight E4980A - GPIB remote control system

222 Keysight E4980A/AL Precision LCR Meter
Overview of Remote Control
GPIB remote control system
8-
GPIB remote control system
What is GPIB?
GPIB (General Purpose Interface Bus) is an interface standard for connecting
computers and peripherals that supports the following international standards:
IEEE 488.1, IEC-625, IEEE 488.2, and JIS-C1901. The GPIB interface allows
you to control the Keysight E4980A/AL from an external computer. The
computer sends commands and instructions to the E4980A/AL and receives
data sent from the E4980A/AL via the GPIB.
System configuration
Use GPIB cables to make connections between the E4980A/AL, the external
controller (computer), and peripherals. Figure 8-1 shows an overview of the
GPIB remote control system’s configuration.
Figure 8-1 Configuration of the GPIB remote control system
㪼㪋㪐㪏㪇㪸㫌㪼㪈㪇㪇㪋
E4980A
Precision LCR Meter
20 Hz - 2 MHz
L CUR
L POT
H POT
H CUR
DC
Bias
USB
DC
Source
UNKNOWN
Discharge test device before connecting
r42V Peak Max Output CAT I
r10VDC Max
DC Source
(Option 001)
Trigger
DC Bias
DC
Source
Return
789
456
123
0
.
Preset
Display
Format
Meas
Setup
Recall A Recall B
Save/
Recall
System
Local/
Lock
㪟㪜 㪮 㪣㪜 㪫 㪫
㪧㪘 㪚㪢㪘 㪩 㪛
㪭㪼㪺㫋㫉㪸
㪋㪏 㪍㪆 㪍㪍 㪯 㪤
㪩㪜㪪㪜㪫
㻷㼑㼥㼟㼕㼓㼔㼠㻌㻱㻠㻥㻤㻜㻭
㪎㪉㪈
㪎㪯㪯
㪎㪈㪎
㪞㪧㪠㪙
㪪㪼㫃㪼㪺㫋㩷㪚㫆㪻㪼
㪞㪧㪠㪙㩷㪘㪻㪻㫉㪼㫊㫊
㪪㪼㫃㪼㪺㫋㩷㪚㫆㪻㪼
㪞㪧㪠㪙㩷㪘㪻㪻㫉㪼㫊㫊
㪪㪼㫃㪼㪺㫋㩷㪚㫆㪻㪼
㪞㪧㪠㪙㩷㪘㪻㪻㫉㪼㫊㫊
㪦㫋㪿㪼㫉㩷㪠㫅㫊㫋㫉㫌㫄㪼㫅㫋㫊
㪚㫆㫄㫇㫌㫋㪼㫉