Keysight E4980A - Comparator:swap; Comparator:tolerance:bin[1-9]

Keysight E4980A/AL Precision LCR Meter 329
SCPI Command Reference
E4980A/AL commands
Parameter
Equivalent key [Meas Setup] - LIMIT TABLE - COMP - ON
[Meas Setup] - LIMIT TABLE - COMP - OFF
:COMParator:SWAP
Syntax :COMParator:SWAP {ON|OFF|1|0}
:COMParator:SWAP?
Description Enables the swap parameter function.
Parameter
Equivalent key [Meas Setup] - LIMIT TABLE - FUNC - SWAP PARAM
:COMParator:TOLerance:BIN[1-9]
Syntax :COMParator:TOLerance:BIN[1-9] <low>,<high>
:COMParator:TOLerance:BIN[1-9]?
Description Sets the lower/upper limit values of each BIN for the comparator function’s
tolerance mode. These limits can be set only when the limit mode is set to the
tolerance mode. When the lower limit or upper limit is not set, it returns
-9.9E37 and 9.9E37, respectively.
Parameter
Equivalent key [Meas Setup] - LIMIT TABLE - LOW
[Meas Setup] - LIMIT TABLE - HIGH
Description
ON or 1 Enables the comparator function
OFF or 0 (Preset value) Disables the comparator function
Description
ON or 1 9 BIN settings are used for the secondary parameter
OFF or 0 (Preset value) 9 BIN settings are used for the primary parameter
<low>,<high>
Unit Depends on :FUNCtion:IMPedance[:TYPE]