Keysight E4980A - Change 5; Change 4; Change 3; Change 2

- 424 Keysight E4980A/AL User’s Guide
Manual Changes
Manual Changes
-
Change 5
The following function and SCPI commands are supported.
o Current Bias Interface is supported.
o :SYSTem:COMMunicate:LAN[:SELF]:RESTart command is available to
restart the network.
o :SYSTem:RESTart command is available to reboot the instrument
immediately.
Change 4
The following options are newly added to the firmware revision A.03.00.
o Option 030, 050, 100 and 200
Change 3
The following functions are newly added to the firmware revision A.02.11.
o Change the resolution to 20mA from 1A to 2A of the DC bias signal current
level at the connection of two 42841A devices.
Change 2
The following functions are newly added to the firmware revision A.02.10.
o Command to set the DC bias range has been added.
The firmware revision A.02.00 and below does not support the following SCPI
command. Please delete the descriptions about this command from this
manual.
— “:BIAS:RANGe:AUTO” on page 323
Change 1
The following functions are newly added to the firmware revision A.02.00.
o New softkey which has LAN reset function.
o Compliant with LXI (Lan eXtensions for Instrumentation) standard Class C
o DHCP ON/OFF function and AUTO IP address ON/OFF function integrated
(IP CONFIG field).
o “Status” which displays the LAN connection status changed (CURRENT
LAN STATUS monitor).