360 Keysight E4980A/AL Precision LCR Meter
SCPI Command Reference
E4980A/AL commands
10-
Equivalent key No equivalent key is available on the front panel.
:MEMory:FILL
Syntax :MEMory:FILL DBUF
Description Enables the data buffer memory to store measurement data. After execution of
this command, all measurement data will be stored in the data buffer memory.
If this has already been enabled, this command will do nothing. (No Query)
Equivalent key [Save/Recall] - SAVE DATA - START LOG
:MEMory:READ?
Syntax :MEMory:READ? DBUF
Description Places the data in the data buffer memory into the output buffer. The output
format of this command is the same as the one for FETC:IMP?. In the preset
state, “9.90000E+37,+9.90000E+37,-1,+0” is returned the number of times
specified by :MEMory:DIM. When the data buffer memory is not filled to the
specified size (specified by the :MEMory:DIM command),
“9.90000E+37,+9.90000E+37,-1,+0” remains for the rest of the data locations.
(Query Only)
Equivalent key [Save/Recall] - SAVE DATA - SAVE & STOP
This key is a combination of both :MEMory:READ? and :MEMory:CLEar.
:MMEMory:DELete[:REGister]
Syntax :MMEMory:DELete[:REGister] <numeric>
Description Deletes the state from the memories. Numbers 0 to 9 are located in the
internal memory, while Nos. 10 to 19 are situated in the external USB memory.
(No Query)
Parameter
Equivalent key [Save/Recall] - No. - DELETE
:MMEMory:LOAD:STATe[:REGister]
Syntax :MMEMory:LOAD:STATe[:REGister] <numeric>
<Numeric>
Range 0 to 19
Resolution 1
To Next Page
Loading...
Need help?
General
