Keysight E4980A - System:communicate:lan[:Self]:Configure; System:communicate:lan[:Self]:Control

Keysight E4980A/AL Precision LCR Meter 367
SCPI Command Reference
E4980A/AL commands
Description Enables automatic IP address setup. The E4980A/AL can obtain an available IP
address at 169.254.xxx.xxx.
Parameter
Equivalent key [System] - SYSTEM CONFIG - AUTO-IP ENABLED - ON
[System] - SYSTEM CONFIG - AUTO-IP ENABLED - OFF
:SYSTem:COMMunicate:LAN[:SELF]:CONFigure
Syntax :SYSTem:COMMunicate:LAN[:SELF]:CONFigure {AUTO|MANual}
:SYSTem:COMMunicate:LAN[:SELF]:CONFigure?
Description Selects automatic obtaining or manual setting for the IP address obtaining
method.
Parameter
Equivalent key [System] - SYSTEM CONFIG - IP CONFIG - AUTO
[System] - SYSTEM CONFIG - IP CONFIG - MAN
:SYSTem:COMMunicate:LAN[:SELF]:CONTrol
Syntax :SYSTem:COMMunicate:LAN[:SELF]:CONTrol
Description Returns the SOCKET control port number. If the parser is a SOCKET, it will
return a number from 5000 to 5100. Otherwise, 0. (Query Only)
This command works with the firmware revision 1.0x. Do not use this
command with the firmware revision 2.00 or later.
Description
ON or 1 (Preset value) Enables automatic IP address setup
OFF or 0 Disables automatic IP address setup
This command is available for the firmware revision 2.00 or later.
Description
AUTO (Preset value) Sets the IP address obtaining method to AUTO
MANual Sets the IP address obtaining method to MAN