Keysight E4980A - Display Setting for Measurement Results

Keysight E4980A/AL Precision LCR Meter 69
Display Format
MEAS DISPLAY Page
Display Setting for Measurement Results
The E4980A/AL can set the display digits and display units for measurement
results (primary parameter/secondary parameter). For measurement
parameters whose “setting available?” column is No in Table 3-22, the display
setting cannot be changed. For measurement parameters whose display digit
can be set to AUTO or FIXED, generally AUTO is selected. Regarding the
display range for measurement values, refer to “Measurement display ranges”
in data sheet in Chapter 11 “Specifications and Supplemental Information”
Table 3-22 shows the digits and units that can be set for each measurement
parameter.
Under certain conditions, a message will be displayed instead of measurement
results. For details, refer to “Displaying Errors instead of Measurement
Results” on page 71
Procedure to change display setting
Step 1. Press the [Display Format] key.
Step 2. Press the MEAS DISPLAY softkey.
Step 3. Use the cursor keys to select the field in which a measurement result of
primary parameter or secondary parameter is displayed.
Step 4. Use the following softkeys to set the display.
Table 3-22 Display Settings for Measurement Results
Measurement
Parameter
Unit Setting
available
?
Display
digits
Supplementary unit Minimum
display
Maximum
display
Vdc V Yes AUTO/FIX a,f,p,n,u,m,k,M,G,T,P,E 1.000000a 999.9999E
Idc A Yes AUTO/FIX a,f,p,n,u,m,k,M,G,T,P,E 1.000000a 999.9999E
R,X,Z,Rdc  Yes AUTO/FIX a,f,p,n,u,m,k,M,G,T,P,E 1.000000a 999.9999E
G,B,Y S Yes AUTO/FIX a,f,p,n,u,m,k,M,G,T,P,E 1.000000a 999.9999E
Cp,Cs F Yes AUTO/FIX a,f,p,n,u,m,k,M,G,T,P,E 1.000000a 999.9999E
Lp,Ls H Yes AUTO/FIX a,f,p,n,u,m,k,M,G,T,P,E 1.000000a 999.9999E
-rad rad Yes AUTO/FIX a,f,p,n,u,m,k,M,G,T,P,E 1.000000a 3.141593
Dn.a.NoFIXn.a. 0.000001 9.999999
Qn.a.NoFIXn.a. 0.01 99999.99
-deg deg No FIX n.a. 0.0001 180.0000
%%NoFIXn.a. 0.0001 999.9999