2N8/2N7
1-2-44
22. Pass the connector of the key counter
wire through the aperture in the opera-
tion mount cover B and refit the opera-
tion mount cover A.
23. Refit the arm hinge cover A, B and
operation mount cover C.
24. Refit the controller box.
25. Refit the rear upper cover.
Figure 1-2-67
26. Peel the protective pad and then affix
two tray films over the tray mount.
Figure 1-2-68
Aperture
Key counter wire
Operation mount cover A
Tray films
Tray mount
To Next Page
