Kyocera TASKalfa 6501i - Page 77

2N8/2N7
1-2-45
27. Fit the tray mount to the operation arm
using two M4 x 20 tap-tight S screws.
Figure 1-2-69
28. Cut out the aperture plate on the tray
cover using nippers.
29. Fit the tray cover to the tray mount
using two M4 x 8 screws.
Figure 1-2-70
Tray mount
M4 x 20
tap-tight S
screw
M4 x 20
tap-tight S
screw
Tray cover
M4 x 8 screw
M4 x 8 screw
Aperture
Tray cover