2N8/2N7
1-2-54
17. Remove two wire holders.
18. Route the MK-2 signal cable through
the wire guide and fix it at two wire hold-
ers.
19. Refit the operation mount cover C.
20. Refit the controller box.
21. Refit the rear upper cover.
Figure 1-2-82
22. Peel the protective pad and then affix
two tray films over the tray mount.
Figure 1-2-83
Wire guide
MK-2 signal cable
Wire holders
Tray films
Tray mount
To Next Page
