Lexmark X548 Series Service Manual

2-26 Service Manual
7525-63x
Go Back
Previous
Next
883 Failure to transmit training successfully
in V.17, V.27 terminal modulation
schemes.
• Select a lower Max Speed under Fax
Send settings.
• Adjust Transmit Level.
• Check line quality.
884 Failure to transmit training successfully
in V.29, V.27 terminal modulation
schemes.
• Select a lower Max Speed under Fax
Send settings.
• Adjust Transmit Level.
• Check line quality.
885 Failure to transmit training successfully
in V.17 terminal modulation scheme.
• Select a lower Max Speed under Fax
Send settings.
• Adjust Transmit Level.
• Check line quality.
886 Failure to transmit training successfully
in V.29 terminal modulation scheme.
• Select a lower Max Speed under Fax
Send settings.
• Adjust Transmit Level.
• Check line quality.
887 Failure to transmit training successfully
in V.27 terminal modulation scheme.
• Select a lower Max Speed under Fax
Send settings.
• Adjust Transmit Level.
• Check line quality.
888 Failure to transmit training successfully
at 2400 bps in V.27 terminal
modulation scheme.
• Adjust Transmit Level.
• Check line quality.
889 Failed to connect at the minimum
speed supported by the MFP.
• Adjust Transmit Level.
• Incompatible connection.
88A Failed to connect using V.34
modulation scheme.
• Check line quality.
• Adjust to a lower modulation scheme.
• Adjust Transmit Level Receive
Threshold values.
901 No fax tones detected from remote
end.
• Verify destination phone number.
• Verify that the remote fax is authorized
to receive faxes.
902 No dial tone detected. • Check by enabling Behind a PABX
setting.
• Check phone line.
• Check MFD modem hardware.
903 Busy tone detected. Check with remote end if successive
attempts fail.
904 Hardware error detected. See “Modem/fax card service check” on
page 2-66.
905 A timeout occurred after dialing the
number and waiting for a response.
Check with remote end if successive
attempts fail.
906 Fax cancelled by user. No action needed.
907 Modem detected a digital line
connection.
Verify the MFP is connected to an analog
line. See“Fax transmission service
check” on page 2-67.
908 Phone line was disconnected Restore phone line connection.
Fax error log codes
Error code Description Action

Lexmark X548 Series Specifications

General

Brand	Lexmark
Model	X548 Series
Category	All in One Printer
Language	English