Gocator Line Profile Sensors: User Manual
Getting Started • 31
Multi-Sensor System
A Master network controller (excluding Master 100) can be used to connect two or more sensors into a
multi-sensor system. Gocator Master cordsets are used to connect the sensors to a Master. The Master
provides a single point of connection for power, safety, encoder, and digital inputs. A Master
400/800/810/1200/2400/2410 can be used to ensure that the scan timing is precisely synchronized
across sensors. Sensors and client computers communicate viaan Ethernet switch (1 Gigabit/s
recommended).
Master networking hardware does not support digital, serial, or analog output.
To Next Page
Loading...
