Gocator Line Profile Sensors: User Manual
Gocator Device Files • 563
Element Type Description
IpAddress String Address in dotted notation (e.g. 1.1.1.1).
PrefixLength 32u Length of prefix for the subnet.
SubnetMask String Address in dotted notation (e.g. 1.1.1.1).
Gateway String Address in dotted notation (e.g. 1.1.1.1).
DeviceName String Profinet name for the device.
Profinet Child Elements
Digital0 and Digital1
The Digital0 and Digital1 elements define settings for the Gocator's two digital outputs.
Element Type Description
Digital0.used Boolean Indicates if the output is available on the sensor.
Event 32s
Triggering event:
0 – None (disabled)
1 – Measurements
2 – Software
3 – Alignment state
4 – Acquisition start
5 – Acquisition end
SignalType 32s
Signal type:
0 – Pulse
1 – Continuous
ScheduleEnabled Bool Enables scheduling.
PulseWidth 64f Pulse width (µs).
PulseWidth.min 64f Minimum pulse width (µs).
PulseWidth.max 64f Maximum pulse width (µs).
PassMode 32s
Measurement pass condition:
0 – AND of measurements is true
1 – AND of measurements is false
2 – Always assert
Delay 64f Output delay (µs or mm, depending on delay domain defined below).
DelayDomain 32s
Output delay domain:
0 – Time (µs)
1 – Encoder (mm)
Inverted Bool Whether the sent bits are flipped.
Measurements 32u (CSV) Selected measurement sources.
Measurements.options 32u (CSV) List of available measurement sources.
Digital0 and Digital1 Child Elements
To Next Page
Loading...
Need help?
General
