Gocator Line Profile Sensors: User Manual
Gocator Web Interface • 318
Filter
This tool is not supported on A and B revision Gocator 2100 and 2300 sensors. It will however
appear in emulator scenarios created using these sensors.
The Filter tool provides several common vision processing filters that you can apply to surface data, as
well as a two "cropping"filters that output a subset of the surface data, letting you pre-process scan data
to get more repeatable measurements. You can enable up to seven of the filters at once, in any order.
Filters in the tool are chained together. Any Surface or Feature tool can use the resulting filtered surface
data as input, via the tool's Stream drop-down.
For a list of the filters, see Filters on the next page.
The Filter tool provides no measurements or decisions, as its only purpose is to output processed
surface data.
2DView (Sobel Magnitude)
3DView (Sobel Magnitude)
Tool Setup
For information on adding, managing, and removing tools and measurements, as well as detailed
descriptions of settings common to most tools, see Tools Panel on page 198.
To Next Page
Loading...
Need help?
General
