Gocator Line Profile Sensors: User Manual
688
Tools and Native Drivers
The following sections describe the tools and native drivers you can use with a Gocator, as well as the
CSVformat that Gocator can export.
Sensor Discovery Tool
If a sensor's network address or administrator password is forgotten, the sensor can be discovered on
the network and/or restored to factory defaults by using the Sensor Discovery software tool. This tool
can be obtained from the downloads area of the LMI Technologies website:http://www.lmi3D.com.
After downloading the tool package [14405-x.x.x.x_SOFTWARE_GO_Tools.zip], unzip the file and run the
Sensor Discovery Tool [>Discovery>kDiscovery.exe].
Any sensors that are discovered on the network will be displayed in the Devices list.
To change the network address of a sensor:
1. Select the Custom option.
2. Enter the new network address information.
3. Click Set Address.
To restore a sensor to factory defaults:
1. Select the sensor serial number in the Devices list.
2. Press the Factory Restore... button.
Confirm when prompted.
The Sensor Discovery tool uses UDP broadcast messages to reach sensors on different subnets.
This enables the Sensor Discovery tool to locate and re-configure sensors even when the sensor IP
address or subnet configuration is unknown.
To Next Page
Loading...
Need help?
General
