LMI Technologies Gocator 2500 Series - Page 528

Gocator Line Profile Sensors: User Manual
Gocator Device Files • 528
Element Type Description
2 – Range
3 – Surface
4 – Section
Stream\Id 32u The stream source ID.
BaseType 32s
Setting for the strip type:
0 – None
1 – Flat
LeftEdge Bitmask
Setting for the left edge conditions:
1 – Raising
2 – Falling
4 – Data End
8 – Void
RightEdge Bitmask
Setting for the right edge conditions:
1 – Raising
2 – Falling
4 – Data End
8 – Void
TiltEnabled Boolean
Setting for tilt compensation:
0 – Disabled
1 – Enabled
SupportWidth 64f Support width of edge (mm).
TransitionWidth 64f Transition width of edge (mm).
MinWidth 64f Minimum strip width (mm).
MinHeight 64f Minimum strip height (mm).
MaxVoidWidth 64f Void max (mm).
Region
ProfileRegion2d
Region containing the strip.
Measurements\X Strip tool
measurement
X measurement.
Measurements\Z Strip tool
measurement
Z measurement.
Measurements\Width Strip tool
measurement
Width measurement.
Measurements\Height Strip tool
measurement
Width measurement.
Element Type Description
@id 32s Measurement ID. Optional (measurement disabled if not
Strip Tool Measurement