LS Industrial Systems XG5000 - Input or Contact Point

Chapter 5 LD Edit
5-4
5.2.3 Input OR contact point
Inputs OR contact point (Normally opened OR contact point, Normally closed OR contact point, Positive-
conversion detection OR contact point, Negative-conversion detection OR contact point)
[Steps]
1. Move the cursor where you want connect OR
2. Select contact point kind at Toolbar and click editing area. Or press shortcut key corresponding to OR
contact point
3. Input device name at dialog box for variable input. For detail on dialog box for variable input, refer to 5.2.4
Note
- In duplicated mode, in case contact point is in cursor, OR connection does not operate