LS Industrial Systems XG5000 - Module Information Setting Based on Slots

Chapter 9 Parameter
9-9
[Description of Dialog Box]
a. Slot: used to input the maximum number of slots.
b. OK: applies the changed items and closes the dialog box.
c. Cancel: closes the dialog box.
Notes
- If the specified number of slots is less than the maximum number of slots, the rest area is unavailable to
edit.
2) Delete Base Module
[Steps]
1. Select the base module to delete from the device list.
2. Click the right mouse button to select [Delete Base].
3. [Delete] or [OK] message box will be displayed. Click [OK] button to delete the information of the
applicable base module.
9.2.2 Module Information Setting Based on Slots
Module type and detailed module information will be described based on slots.
[Steps]
1. Select the slot to specify the module in the slot information.
2. Select the arrow of the Module to display the module selection box. Or click the right mouse button to
select [Edit].