Chapter 5 LD Edit
5-16
Notes
- The vertical line will be inputted downward to the left from the location of the present cursor.
5.2.6 Input Coil
It is used to input the coils (coil, reverse coil, positive-conversion detection coil and negative-conversion
detection coil).
[Steps]
1. Move the cursor to the location to input the coil on.
2. On the tool box, select the type of the coil to input and then click the edit area. Or click the Shortcut Key
applicable to the coil to input.
3. After a variable name is input on the Variable Selection Dialog Box, click [OK].
Notes
- If a coil and output related application instruction is inputted, a horizontal line will be automatically inputted
to connect with the left factor.
- When there is duplicate coil, outputs to output module according to last coil status.
To Next Page
Loading...
