LS Industrial Systems XG5000 - Chapter 8 Find;Replace; 8.1 Find Device

Chapter 8 Find/Replace
8-1
g
c
d
f a
b
h
e
Chapter 8 Find/Replace
This is used to find or change the device and the String in LD, SFC and Variable/Comment of XG5000
8.1 Find Device
This function is used to find the device previously made in LD Editor, SFC Editor, or Variable/Comment Editor
[Dialog Box]
[Description of Dialog Box]
a. Find what: used to specify the device to find.
b. Find including lower type: used to select the device type containing the device to find. Then, if checking
the checkbox, it finds %IB0.1.0, %IW0.1.0, %IL0.1.0 and others containing %IX0.1.1.
c. Output to pane 2: XG5000 has two Find result windows. Basically the result is yielded to Find 1 result
window, but if this check box is selected, the result will be yielded to Find 2 result windows.
d. Direction: used to specify the location to find upward or downward from the line presently selected in the
respective editor.
e. Range: selects it to fine by designating a specific line after designating the direction. If Range is selected,
the start and end lines should be also entered.
f. Find Next: finds the detail specified above right in the next to the line (position) presently selected. If the
applicable device is found, the position the applicable device is located will be selected.
g. Find All: finds all the details specified above to display the result on the find result window.
h. Advanced>>: It is only used in LD editor. ‘Advanced>>’ and ‘Advanced<<’ is changed by click. It is used to
find specific contact point, specific coil and extended function and function/function block used in LD
editor