Chapter 18 Dedicated XGR Function
18-7
System configuration contains below information.
1. Connection state between base
2. Connection cable type between base
3. In case of electric cable, it displays measured time and distance.
4. It displays data synchronization cable between Master and Standby CPU.
5. It displays base information of selecting base by clicking mouse button (or pressing enter key).
18.4.2 Node Count change
Node Count change makes to decide how many node displays in window.
To change Node Count, selects [View] – [Node Count], then selects node among [2], [3], [4], [5], [6].
Default setting value is 2.
1. [View] - [Node Count] - [2]
To Next Page
Loading...
