Chapter 12 Debugging
12-1
Chapter 12 Debugging
12.1 Start/Stop Debugging
12.1.1 Start Debugging
[Sequence]
1. Select [Online]-[Connect] on the menu to connect with PLC.
2. Select [Online]-[Write] on the menu to download the program onto PLC.
3. Select [Online]-[Change Mode]-[Debug] or [Debug]-[Start/Stop Debugging] on the menu.
Notes
- This function is available only with PLC connected in online
- Debug is unavailable if PLC operation is in Run mode.
- Debug function is available with XG5000 program and PLC program identical to each other. If they are
not identical, download the applicable program.
- Monitoring function is also available in Debug mode.
- If any error occurs on PLC, Debug instruction will not work normally. Clear the error to execute the
Debug instruction.
12.1.2 Stop Debugging
[Sequence]
1. Select [Online]-[Change Mode]-[Stop] or [Debug]-[Start/Stop Debugging] on the menu.
2. PLC will end Debug and come to the Stop mode.
Notes
- Even if Debug stops, Monitor does not end.
To Next Page
Loading...
