Chapter 5 LD Edit
5-3
5.2.2 Input Contact point
This is used to input the contact points (normally open contact, normally closed contact, positive-conversion
detection contact and negative-conversion detection contact).
[Steps]
1. Move the cursor to the location to input the contact point on.
2. On the tool box, select the type of the contact to input and then click the edit area. Or click the Shortcut
Key applicable to the contact to input.
3. After the device name is input on the Variable Input Dialog Box, click [OK]. Refer to 5.2.3 Variable/Device
Input for details on the Variable Input Dialog Box.
Notes
- Select [Tool]-[Option] on the menu. If the Input mode is promptly released from the Edit page, the Variable
Input Dialog Box will not be automatically displayed when inserting a contact point and coil.
- The basic operation of Enter key is to input identical kind of instruction used previous edit.
Example) If a normally open contact is input and entered in the previous edit, the normally open contact
input dialog box will be displayed when enter key is pressed.
To Next Page
Loading...
