Chapter 11 Monitoring
11-99
11.8.5 Animation
Using the trace data read from PLC, it displays the data in the sequence of time.
1) Animation Settings
[Steps]
1. Select [Animation]-[Animation Setting] on the menu.
[Dialog Box]
[Description of Dialog Box]
a. Frequency: used to specify the cycle to update the data sample on the screen. Available data update
cycles are 20, 50, 100, 200, 500, 1000 and 2000ms value.
b. OK: applies the changed items and closes the dialog box.
c. Cancel: closes the dialog box.
2) Start
It is used to start Simulation. Simulation will be active only with trace data available.
[Steps]
1. Select [Animation]-[Start Animation] on the menu.
3) Pause
It is used to stop Simulation in progress momentarily.
[Steps]
1. Select [Animation]-[Animation Pause/Resume] on the menu.
4) Resume
It is used to continue Simulation which was momentarily stopped.
a
b c
To Next Page
Loading...
