Chapter 11 Monitoring
11-29
Notes
a. If the system synchronization executed, the module information only will be updated.
b. Refer to Basic Parameter Information for details on I/0 assignment method.
11.4.4 All I/O modules ON/OFF
It is used to check output value of all the I/O modules installed on PLC.
1) All I/O modules ON
It makes the data value of all the I/O modules installed on PLC be On.
[Steps]
1. Confirm the connection status with PLC.
2. Select [PLC]-[All I/O modules ON] on the menu.
2) All I/O modules OFF
It makes the data value of all the I/O modules installed on PLC be Off.
[Steps]
1. Confirm the connection status with PLC.
2. Select [PLC]-[All I/O modules OFF] on the menu.
11.4.5 Selected I/O modules ON/OFF
It is used to check output value of the selected I/O modules installed on PLC.
1) Selected I/O module ON
It makes the data value be ON as many as the contact points of the selected I/O modules on the base
displayed on PLC screen.
[Steps]
1. Confirm the connection status with PLC.
2. Select [PLC]-[Selected I/O modules ON] on the menu.
To Next Page
Loading...
