LS Industrial Systems XG5000 - Read All Data from PLC; Monitor Start;End

Chapter 11 Monitoring
11-115
11.9.11 Read all data from PLC
It reads all loop data from PLC. You can check progress through progress bar at bottom of PID monitor
[Sequence]
Select [PLC]-[Read All]
11.9.12 Monitor start/end
1) Start Monitoring
It reads PID data value in PLC connected and indicates at screen
[Sequence]
Check if PLC is connected
Select [PLC]-[Start Monitoring]
2) End Monitoring
It stops monitoring PID data value of PLC
[Sequence]
Select [PLC]-[End Monitoring]
Note
In case of monitor mode, you can’t edit detail setting. You can change setting value only by [Edit]-[Change
Current Value]
In case of monitor mode, you can’t execute [PLC Write], [PLC Read], [Loop Open] and [Loop Save] is
only available.