Chapter 11 Monitoring
11-7
11.2 LD Program Monitoring
With XG5000 in monitoring status, it displays contact points prepared in LD diagram (ordinarily open contact
point, ordinarily closed contact point, positive-converted detection contact point, negative-converted detection
contact point), coils (coil, reverse-coil, set coil, reset coil, positive-converted detection coil, negative-
converted detection coil) and function(block) I/O parameter’s current value.
[Monitor Start Steps]
1. Select [Monitor]-[Start/Stop Monitoring] on the menu.
2. LD program will be changed to monitoring mode.
3. Change Current Value: Select [Monitor]-[Change Current Value] on the menu.
[Monitor display of contact point]
1. Ordinarily open contact point: If applicable contact point’s value is On status, device (or variable) value will
be displayed in red, and the power flow inside the contact point in blue
Notes
a. Monitor-related color described in this manual is provided basically by XG5000. Applicable color may be
changed on the menu [Tools]-[Options]. Refer to the option item in Chapter 2. Basic Application for more
details.
2. Ordinarily closed contact point: If applicable contact point’s value is On status, device value will be displayed
in red, and the power flow inside the contact point will not be displayed.
To Next Page
Loading...
