Chapter 9 Parameter
9-8
Notes
- The XGI project type supports the fixed allocation type only. Therefore, the allocation information column is
always displayed as deactivated.
d. Delete Slot: deletes all information of the presently selected slot.
e. Delete Base: deletes all information of the presently selected base.
f. Base Setting: sets slot number on base currently selected base.
g. Delete All: deletes all information of all bases.
h. Details: displays detailed module information.
Notes
- Refer to XG-PD manual for details on the communication module information setting.
- Refer to APM manual for details on the positioning module information setting.
b. Print: prints the module type and the module’s parameter information specified in the slot.
c. OK: applies the changed items and closes the Dialog Box.
i. Cancel: closes the Dialog Box.
9.2.1 Base Module Information Setting
1) Base Module Information Setting
It is used to specify the base information about module.
[Steps]
1. Select the base module to specify from the device list.
2. Click the right mouse button to select [Base Setting]. Or click Base Setting button.
[Dialog Box]
a
b c
To Next Page
Loading...
