Chapter 8 Find/Replace
8-7
a
b
c
d
e
f
g
f
g
h
i
8.2 Find Text
This function is used to find the String of Rung Comment, Variable, Variable Comment, Application
Instruction and Label except the device.
[Dialog Box]
[Description of Dialog Box]
a. Find what: used to specify the String to find.
b. Match whole word only: If All Identical checked, it will find the string only exactly identical to the string
specified in the detail to find. If not checked, it will find also the string where the detail to find is included.
c. Case-sensitive: If this checked, it will find the string only exactly identical to the string with Case-sensitive
characters sorted out. If not checked, it will find the string in characters not sorted out.
d. Output to pane 2: XG5000 has two Find result windows. Basically the result is yielded to Find 1 result
window, but if this check box is selected, the result will be yielded to Find 2 result windows.
e. Direction: used to specify the location to find upward or downward from the line presently selected in the
respective editor.
f. Find Next: finds the detail specified above right in the next to the line (position) presently selected. If the
applicable String is found, the position the applicable String is located will be selected.
g. Find All: finds all the details specified above to display the result on the Find result window.
h. Range: if Range is selected, Find Sting is executed in a specific step. If Range is selected, the start and
last steps should be also entered.
i. Advanced>>: It is only used in LD editor. ‘Advanced>>’ and ‘Advanced<<’ is changed by click. It is used to
find specific contact point, specific coil and application instruction used in LD editor.
To Next Page
Loading...
