Chapter 10 Online
10-13
10.3 Write
It is used to transfer user programs, respective parameter and comment to PLC.
[Steps]
1. Select [Online]-[Connect] to connect to PLC via Online.
2. Select [Online]-[Write].
3. Select the data to transfer to PLC and then click [OK] to start to transfer the selected data to PLC.
[Dialog Box]
[Description of Dialog Box]
a. Selection Tree: selects the data to transfer to PLC.
b. OK: starts to transfer the data to PLC if clicked.
c. Cancel: cancels to write data.
d. Clear PLC: recalls dialog box to clear internal memory area, parameter and program
(For more detail, refer to ’10.8 Clear PLC’)
- Notes
- XGI/XGR retain area device holds previous value though you write the program. In order to initialize the
retain area, execute ‘Clear PLC’ function to clear the area you want
- For description on data retain area, refer to each CPU user manual.
b
a
c
d
To Next Page
Loading...
