LS Industrial Systems XG5000 - Insert Line; Delete Factor

Chapter 5 LD Edit
5-29
5.2.13 Insert Line
It is used to insert a new line in the present cursor position.
[Steps]
1. Move the cursor to the location to insert the line in.
2. Select [Edit] - [Line Insert].
Notes
- If Line Insert is executed, a new line will be inserted in the present cursor position.
- If an area is selected for Line Insert, new lines as many as the lines in the selected area will be inserted.
- If function (block) is contained, line can not be inserted.
5.2.14 Delete Factor
It is used to delete the input contact point, coil, function (block), line, rung/output comment and label.
[Steps]
1. Move the cursor to the location to delete the factor from.
2. Select [Edit] - [Delete].