Chapter 11 Monitoring
11-30
2) Selected I/O module OFF
It makes the data value be Off as many as the contact points of the selected I/O modules on the base
displayed on PLC screen.
[Steps]
1. Confirm the connection status with PLC.
2. Select [PLC]-[Selected I/O modules OFF] on the menu.
11.4.6 Change Current Value
In order to change the current value, it shall be in the connection status with PLC and in monitoring mode.
Click the contact point to change the data value of the selected contact point to ON or OFF.
[Steps]
1. Confirm the connection status with PLC and the monitoring mode.
2. Position the mouse cursor on the I/O module’s contact point to change the cursor to hand shape.
3. Click the I/O module’s contact point.
Notes
a. Move the mouse onto I/O contact point to display the assigned device on the status bar.
b. If I/O skip is specified, it will be displayed always OFF.
To Next Page
Loading...
